These are a direct replacement for the stock traction rods designed to improve traction with superior construction and functionality. Turnbuckle allows for length adjusting for further fine tuning while pillow ball joints allow for much more sports oriented handling.
Get this and all your JDM at RHDJapan!
Get this and all your JDM at RHDJapan!
Brand: Yanack
Product: Pillow Traction Rod - JZA70
Part Num: YK-008-03
SPECIFICATIONS:
Type: Hollow Hexagonal Rod
Material: Steel (S45C)
Type: Adjustable Turnbuckles
Pillow Ball Size: M16
Pillow Ball Type: Japan IKO (Japan Thompson)
Product: Pillow Traction Rod - JZA70
Part Num: YK-008-03
SPECIFICATIONS:
Type: Hollow Hexagonal Rod
Material: Steel (S45C)
Type: Adjustable Turnbuckles
Pillow Ball Size: M16
Pillow Ball Type: Japan IKO (Japan Thompson)
Toyota Supra JZA70 1JZ-GTE (08/1990-04/1993)
Customers who bought this product also purchased
Product Reviews
Submit a review now and earn 20 Reward points once the review is approved.
Applies only to registered customers, may vary when logged in.
“ THE CUSTOMER'S VOICE ”
RHDJapan Store Reviews
Great Calendar Review by Krishneil
This was provided as a gift and goes well in my garage.
Works great Review by Krishneil
Works great in my GRS204 Crown to adjust rear camber. Installed together with second upper arm.
Great Item Review by Krishneil
Works great in my GRS204 Crown to adjust rear camber.
Great item by Cusco Review by Krishneil
I used this to add additional negative camber on my JZX110 as the JZX110 version was a little lacking. Putting the JZX100 version on allows much more negative camber (-5 to -7 deg)
Overall a great item for handling Review by Krishneil
Installed this item on my JZX110 and it has provided more feel to the rear of the car.
My only issue I found was 3 of the 4 corners lined up perfectly however 1 corner bolt holes were out by almost 5mm. I had to oval the holes out. Another friend also had a similar issue so please keep this in mind if you are purchasing this for a JZX110.
My only issue I found was 3 of the 4 corners lined up perfectly however 1 corner bolt holes were out by almost 5mm. I had to oval the holes out. Another friend also had a similar issue so please keep this in mind if you are purchasing this for a JZX110.
