Works Bell Standard Boss Kit - 520

Brand: Works Bell
Product: Standard Boss Kit - 520
Part Num: 520

SPECIFICATIONS:
Material: Aluminum

PRODUCT NOTES:
- Airbags(mechanical) is not equipped with warning lamp in meter panel.
- Please check the terminal type for horn wiring; for coupler terminal=#520. See fig. 5-1.

COMPATIBILITY NOTES:
- SW20: Only for MR-2 equipped with coupler terminal for horn wiring 12/89~11/91
- SW20: Only for MR-2 Not compatible with vehicles equipped with airbags 12/91~9/99
- SW20: Only for MR-2 equipped with airbags(mechanical) 12/91~9/99
- ​SV35 SV30 SV32 SV33 VZV30 VZV31 VZV32 VZV33 CV30 SV32 SV33: Only for Camry/Vista equipped with coupler terminal for horn wiring 7/90~6/94
- AT190 AT191 AT192 CT190 CT195 ST190 ST195: Only for Carina 8/92~8/96
- ST201 ST202 ST203 ST205 ST200: Only for Carina/Carina ED/Corona ExiV equipped with coupler terminal for horn wiring 10/93~7/96
- EL44: Only for Cynos equipped with coupler terminal for horn wiring 1/91~8/95
- ST182 ST183 ST183C ST185 ST185H: Only for Celica equipped with coupler terminal for horn wiring 9/89~9/93
- RZH101G RZH100G RZH102V LH100G LH107G LH107 LH107W RZH111G RZH110G RZH112K RZH112V LH110G LH117G RZH122V LH120G LH123V LH129V RZH124B RZH125B LH140G RZH182K RZH183K: Only for Hiace/Regius Ace equipped with coupler terminal for horn wiring 8/89~9/93
- SX80 LX80 GX81 JZX81 MX83 YX80 YX80Y: Only for Mark II/Chaser/Cresta equipped with coupler terminal for horn wiring 8/88~10/92
INSTALLATION NOTE:
INSTALLATION NOTE:
These items are manufactured from either cast or billet aluminum process. Manufactured in conjunction with strict quality assurance practices of ASEA (Autosports & Special Equipment Association) under NAPAC (Nippon Auto Parts Aftermarket Committee). Manufactured to be extremely durable for sports/competition application and brake away under severe impact reducing potential harm to driver.
Incorrect installation may occur during installation especially on tapered tooth type design. If the item is not perfectly lined up or slippage occurs the excess stress my crack under torque load. Please make sure to remove all grease from steering shaft and set the boss kit to its most flush mounting position prior to applying torque.
For any possible claim during installation please follow the installation requirements with video proof.
- Maximum torque set between 3~3.5kg/m.
*Torque wrench operation needs to be done with two hands, one on the handle and one holding perfect center and straight positioning.
**Steering wheel / shaft should be held from turning when being torqued down to get proper readings.
***Torque wrenches for heavy duty operation such a lug nuts can be more difficult to get smaller accurate readings for low torque specification.